Reversing The Door - AVG VPC46DS2 Manuel D'utilisation

3. OPERATING YOUR APPLIANCE (continued)
Proper operation of the appliance is guaranteed only if the following conditions are met:

The room temperature where the appliance is located conforms to class stated on rating label.

Maximum ambient relative humidity: RH75%.

The appliance must be placed at a sufficient distance from heat sources (e.g., ovens, central
heating, direct sunlight, etc.).

The appliance must be located in such a place that it is protected against the effects of weather.

Regular maintenance is performed according to the instructions in this user's manual.

The ventilation openings on the appliance must not be covered.

Correct installation (e.g. leveling, capacity corresponds to the specifications on the rating label).

REVERSING THE DOOR

IMPORTANT: THIS OPERATION REQUIRES AT LEAST TWO (2) PERSONS.
INSTRUCTIONS
1. Open the door at a 90ᵒ angle, take out two screws from lower door axis (#3) and pull out door.
2. Set the door aside in a safe place and take out decorative nail (#7) from top of door frame. Remove
the two screws (#4) at bottom and take out the Extrusion-board of lamp switch (#5). Install the
Extrusion-board of lamp switch (#5) at top of door frame and use spare decorative nails to block the
hole at top of door frame.
3. Unscrew the three screws (#8) from top right hinge (#6) and take out the right top hinge.
4. Remove the decorative nails (#10) from left top of cabinet and install the spare top hinge (#9) at left
top of cabinet using the three screws.
5. Install spare lower hinge (#11) onto left lower cabinet.
6. Rotate the door 180ᵒ then re-install it in the same way it was removed, making sure it is aligned
properly.
7. Block the hole at right top of cabinet with the spare decorative nail.
26