Reversing The Door - AVG BSC27SB2 Manuel D'utilisation

REVERSING THE DOOR

IMPORTANT: THIS OPERATION REQUIRES AT LEAST TWO (2) PERSONS.
INSTRUCTIONS
1. Open the door and remove the two screws under the door right bottom corner that are used to hold the
right lower hinge. Be careful to hold the door with hands to prevent dropping the door after removing the
screws.
2. Pull down to remove the door and place it on a padded surface to prevent scratching it.
3. Remove the door shaft from the right upper hinge then install and tighten it in the left upper hinge.
4. Revolve the door 180 degrees. Unscrew 2 screws at the bottom of the door and remove the Reed Switch,
then install the Reed Switch at the top of the door frame.
5. Carefully insert the door into the upper left hinge.Slide the door on top of the lower hinge and secure the
door by installing the lower screws.
6. Slide the door on top of the lower hinge and secure by installing the lower screws.
29