Installing The Handle; Operating Your Appliance; Controls - AVG Mondovino MVP46DS2 Manuel D'utilisation

2. INSTALLATION INSTRUCTIONS (continued)

INSTALLING THE HANDLE

To install the handle, please follow the following instructions:
1. Pull away the door gasket in the area where the handle is to be installed on the left side as
shown below in Fig. 1. The gasket is easily displaced by hand, no tools are necessary.
2. Align the handle with the screws installed. Tighten the screws using a Phillips head screwdriver
until the handle sets both flush and secured tightly against the door frame. DO NOT over
tighten as this will cause damage to the handle assembly. See Fig. 2. Replace the door gasket
to its original position.
Note: The illustrations above are for your reference only. The handle on you unit may be different.

3. OPERATING YOUR APPLIANCE

CONTROLS


" ": ON and OFF button: press and hold for three (3) seconds to turn the unit on or off.

" ": 'Energy Conservation' button: press and hold for three (3) seconds to turn the
energy conservation mode ON or OFF. In this mode, the LED light and display will turn off
and the °C/°F light will be on.

" ": Indicator light: shows that the compressor is in operation.

" " Increase button: press to increase temperature in increments of 1 degree (F or C).

" " Decrease button: press to decrease temperature in increments of 1 degree (F or C).

"°C/°F" Degree button: press to switch the temperature degrees between °C / °F.

" " Light button: turns the interior light ON and OFF. If you use this button, the light is
no longer controlled by the switch and remains ON (the Light button is deactivated when
'Energy conservation' button is on). LED display screen shows the temperature setting.
20