AVG Mondovino MVP46DS2 Manuel D'utilisation page 17

1. IMPORTANT SAFETY INSTRUCTIONS (continued)
SAFETY PRECAUTIONS (continued)

This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities or lack of experience and knowledge unless they have been
given initial supervision or instruction concerning use of the appliance by a person
responsible for their safety. Children should be supervised to ensure that they do not play
with the appliance.

Do not store explosives or sprays using combustible propellants such as butane, propane,
pentane, etc., in the appliance.

You may identify such sprays by the printed contents or a flame symbol.

Do not use electrical devices inside the appliance.

Electrical components might cause leaking gas to ignite.

DANGER: Before you throw away your old appliance:
• Take off the door.
• Leave shelves in place so that children may not easily climb inside.

When disposing of your appliance, please choose an authorized disposal site.

Do not under any circumstances cut or remove or bypass the third (ground) prong from the
power cord.

Do not locate the appliance in direct sunlight or in a room with a high ambient temperature
or in the vicinity of any sources of direct heat, such as a radiator or oven.

To prevent back and other types of injuries, use at least two (2) people to move and install
the appliance.

Install the appliance in a well ventilated area.

Only use in an upright position on a flat, level surface and provide proper ventilation.

Do not pinch or kink the power supply line between the unit and cabinet.

Do not place any other appliances on top of the unit.

Do not turn the unit upside down, on its side or at an angle off level.
BE CAREFUL WHEN HANDLING, MOVING, AND USING THE APPLIANCE TO AVOID EITHER DAMAGING
THE REFRIGERANT TUBING OR INCREASING THE RISK OF A LEAK.
WARNING
If the appliance is transported in a horizontal position, the compressor may leak into the cooling circuit.
For this reason, allow the appliance to rest in a vertical position for 24 hours before turning it on, so
that all fluids flow back into the compressor.
Remove the external packaging, remove the protective plastic film from the surface of the appliance
and clean the external parts of the appliance with a cleaner designed for this purpose. Do not use steel
wool or any coarse agents, which could irreparably damage the surface of the appliance.
17