Wine Storage; Temperature Settings; Functions; Temperature Memory Function - AVG Mondovino MVP46DS2 Manuel D'utilisation

3. OPERATING YOUR APPLIANCE (continued)

WINE STORAGE

If you are storing wine for long periods of time, it should be stored at a temperature of between 10° C
and 14° C (50° F and 57° F). The following drinking temperatures are recommended for the various
types of wine:
Red wines:
Rosé wines:
White wines:

TEMPERATURE SETTINGS

The zone temperature may have a difference of +/‐ 5°F (+/‐ 3ºC) from the setting depending on loading
and ambient conditions. For example, placing your unit in extreme cold or hot conditions may cause
interior temperatures to fluctuate.
To set the temperature:

Use the
are pressed, the temperature will increase / decrease by increments of 1 degree.

When you press the button once, the temperature will increase or decrease by 1 degree. If
you try to go beyond the minimum/maximum value that can be established, the display
will jump to the lowest/highest adjustable temperature value automatically. If a button is
not pressed for five (5) seconds, the LED will stop flashing and the setting mode will be
exited.

You can set the temperature in the range of 39° F to 64° F (or 4° C to 18° C).

FUNCTIONS

TEMPERATURE MEMORY FUNCTION
If the power is suddenly lost, the set temperature will be saved by the unit. Once the power is back
on, the unit will be at the same set temperature.
"CLOSE DOOR" REMINDER FUNCTION
Should you forget to close the door or the door is not fully closed, a warning alarm will sound after
five (5) minutes.
TEMPERATURE ALARM FUNCTION
If the interior temperature is higher than 73° F (23° C), the message "HI" appears on the display panel
and an alarm sounds continuously after one hour. This indicates that the inner temperature is too
high and you should look for the reason. If the inner temperature is lower than 32° F (0° C), the
message "LO" appears on the display panel; the alarm and the malfunction indicator light go on at
the same time.
NOTES
If too many bottles are put in at once or the door has not been closed tightly, the unit will display the
"HI" signal on the display panel. This is normal. Please wait five (5) minutes after closing the door and
"HI" message will disappear.
It is normal that the display shows "HI" or "LO" from time to time. If it occurs frequently or lasts for a
long time, you can restart the unit by unplugging it, then re‐plugging after five (5) minutes. If the
problem occurs again after restarting, please contact customer service.
57°F to +64°F (+14°C to +18°C)
50°F to +54°F (+10°C to +12°C)
46°F to +54°F (+8°C to +12°C)
/ buttons to select the desired temperature. Each time the
21
/ buttons