BEFORE USING YOUR WINE CELLAR
Remove the exterior and interior packaging.
Before connecting the Wine Cellar to the power source, let it stand upright for approximately 24 hours. This
will reduce the possibility of a malfunction in the cooling system from handling during transportation. After
plugging the appliance into a wall outlet, allow the unit to cool down for 3 ~ 4 hours before placing wine
bottles in the appliance.
Clean the interior surface with lukewarm water using a soft cloth.
2. INSTALLATION INSTRUCTIONS
This unit is designed for a freestanding or built-in installation. For a built-in installation, please refer to the below
drawing.
BUILT-IN INSTALLATION
Opening must be at least 24 inch (width and depth)
The cutout dimension illustrated in below figure allows for door swing and access to the pull-out shelves when
installed as a built-in appliance.
If installing between frameless cabinets, a ½" wide filler strip or side panel may be needed on the hinge side.
The filler strip will act as a spacer between the appliance case and adjacent cabinet door swing.
The width of the opening must include the filler panels.
Note: The door should protrude at least 1" beyond the surrounding cabinets and allow 2" of air space between
the rear of the unit and the wall .
24 1/2"
including handle
19
23 1/4"
34"
23 ½"