Hardware Installation - Velleman CAMTVI7N Mode D'emploi

CAMTVI7N/CAMTVI7WN/CAMTVI8N/CAMTVI8WN
4. Features
This HD CCTV camera is equipped with a CMOS image sensor. The
video image quality is 1080P. The video signals can be set to HD-TVI, HD-
CVI, AHD and analogue video signals. The IR-cut filter will filter the IR
light, so it cannot distort the colour image. When it gets dark, the camera
automatically switches to night mode. In night mode, the camera enables
the IR LEDs and disables the IR-cut filter.
 weatherproof
 with B/W night vision (IR LEDs)
 1080P video signal
 vandal-proof bracket
 varifocal lens (CAMTVI8(W)N only)
5. Overview
Refer to the illustrations on page 2 of this manual.
1 mounting plate
2 fixation ring
3 positioning ring
4 manual zoom
5 lens enclosure (sphere)
6 IR night LEDs
6.

Hardware installation

Refer to the illustrations on page 2 of this manual.
 Choose a location for the camera, keeping following guidelines in mind:
do not install the camera in locations where extremely high or low
o
temperatures or excessive vibrations may occur.
avoid mounting the camera near high electro-magnetic fields.
o
do not aim the camera at the sun or other extremely bright objects
o
or reflections (e.g. metal doors).
 Hold the mounting plate [1] and unscrew the fixation ring [2] by
turning it counter-clockwise. Note that the lens enclosure [5] and
positioning ring [3] are also released.
 Use the mounting plate [1] to determine the position of the mounting
holes. Drill the holes.
 Guide the power and video cable [11] through one of the cable slots
[10] and fix the mounting plate [1] on the ceiling or wall with the four
screws.
 Position the positioning ring [3] over the lens enclosure [5] onto the
mounting plate [1] and then fix the ensemble by screwing the fixation
ring [2] onto the mounting plate [1]. Make sure the fixation ring is not
V. 01 – 18/07/2016
7 lens
8 manual focus
9 light sensor
10 cable slot
11 cable
5 ©Velleman nv