Osd Settings - Velleman CAMTVI7N Mode D'emploi

CAMTVI7N/CAMTVI7WN/CAMTVI8N/CAMTVI8WN
screwed too tight to leave the option open to position the lens into the
direction of the desired field of operation.
 Connect the two wires for an analogue PAL signal; leave them
unconnected for a HD 1080P TVI signal.
 Connect the video connector [A] to a monitor (not incl.) or a sequential
switcher/quad splitter (not incl.) in case of multiple domes.
 Connect the power connector [B] to a 12 VDC power supply (not incl.).
 Set up the desired field of observation by adjusting the position of the
lens enclosure [5] in the positioning ring [3].
 Manually adjust the zoom [4] and focus [8] with their screws. The
location of the screws can be determined by looking at the position of
the light sensor [9].
 Tighten the fixation ring [2] to secure the camera's position.
7.

OSD Settings

There is a small joystick in the camera cable that allows you to adjust the
settings of the camera using an on-screen display (OSD).
In the OSD menu:
 NEXT/BACK: select this option and press the middle button to go to the
next/previous page of options in the menu.
 RETURN: select this option and press the middle button to return to the
previous level in the menu.
 EXIT: select this option and press the middle button to leave the OSD
menu without saving the settings.
 SAVE ALL: select this option and press the middle button to save all
settings.
 CAMERA RESET: select this option and press the middle button to reset
the camera to the factory defaults.
The OSD menu settings are described in detail below.
Refer to the table on page 3.
V. 01 – 18/07/2016
 Press the middle button to access the menu, or to
select an option.
 Press the up and down buttons to move up and
down in the menu.
 Press the left and right buttons to modify the menu
parameters.
6 ©Velleman nv