System Installation - Velleman CAMSETW12 Notice D'emploi

b. Receiver
1. aerial
2. power input
3. A/V output
4. power LED
5. channel DIP switches
6. USB connector
7. DC power adapter
8. A/V cable
4. Installation
a. Camera
Select a suitable location which is dry and as dust-free as possible, and presents good air circulation and little
vibrations. The location must not be screened off by reinforced concrete walls, mirrors, metal shelves, etc. and
should be exempt of appliances emitting a strong electric field. Any strong electric environment could cause
interference. Make sure there is a mains outlet in the vicinity.
Fasten the wall bracket to a wall using the included screws. Use nylon plugs if
necessary. Make sure the wall is exempt of any electric wiring before drilling.
Note: Do not point the camera directly towards a source of light as this could lead
to overexposure and an unclear picture.
b. Receiver
Set up the receiver on a rugged and stable surface at approximately 1m above the ground for better reception. Make
sure there is a mains outlet in the vicinity.
5. Connection
a. Camera
• Connect the AV cable to a suitable monitor or TV set (white plug = audio,
yellow = video) as illustrated.
• Connect the power supply.
• Select the correct channel according to the channel selected on the receiver
(see "6. System Installation").
b. Receiver
• Connect the USB plug with the USB port of the computer (see
"10. Technical Specifications – System Requirements").
• Insert the included CD-ROM into the drive and install the
CamGuard software and the driver (see "7. Software").

6. System Installation

Unplug the devices from the mains prior to setting the channel.
CAMSETW12
- 4 - VELLEMAN