Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
NSR83-21
NSC83-28
NSC83-34
6
OPERATING THE NAILER
1
1
ƒ The switch is in the upward position as shown in the
Switch
2
ƒ Depress the contact arm against the work surface
2
3
ƒ The switch is in the downward position as shown in
4
ƒ Hold the trigger and depress the contact arm against
3
Switch
4
ƒ Use INTERCHANGE pneumatic tool lubricant. Do
ƒ Filter-regulator-lubricator units should always be
ƒ If a lubricator is not available, supply 3 to 5 drops of
Interchange Brands Framing Nailers: Operator's Manual
(Options for all tool models)
METHODS OF OPERATION
Single Fire
illustration at the left.
and pull the trigger. Tool cannot fire a second nail
until the trigger is released and tool can cycle.
Bump fire (Multi-Fire) *
the illustration at the left.
the work surface.
*Caution: do not carry tool with trigger
depressed. This could result in accidental
firing of the tool.
LUBRICATION
It is important that the tool be properly lubricated.
Without proper lubrication, the tool will not work
properly and parts will wear prematurely.
not use detergent oil or additives. These lubricants
will harm the O-rings and other rubber parts. This will
cause the tool to malfunction.
used. Keep the lubricator filled with INTERCHANGE
pneumatic tool lubricant.
INTERCHANGE pneumatic tool lubricant into the air
plug on the tool twice a day.
Publicité
Table des Matières
