Sony VPL-FX200U Mode D'emploi page 31

POWER SAVING
When set to ON, the projector goes into the power
saving mode and the lamp for light source turns off if
no signal is input for about 10 minutes.
The power saving mode is canceled when a signal is
input or any key is pressed.
SET SETTING
STATUS: ON
SPEAKER: ON
LANGUAGE: ENGLISH
INSTALLATION: FLOOR-FRONT
POWER SAVING: OFF OFF
SIRCS RECEIVER: FRONT&REAR ON
GROUP INDEX: 0 1
DEVICE INDEX: 0 1
SIRCS RECEIVER
Selects the remote control detectors to be activated.
Change the setting if the wireless Remote Commander
does not work properly due to the influence of the
fluorescent lamp, etc.
SET SETTING
STATUS: ON
SPEAKER: ON
LANGUAGE: ENGLISH
INSTALLATION: FLOOR-FRONT
OFF
POWER SAVING:
SIRCS RECEIVER:FRONT&REAR FRONT&REAR
GROUP INDEX: FRONT 0 1
DEVICE INDEX: REAR 0 1
OFF
FRONT & REAR: Activates both the front and rear
detectors.
FRONT: Activates the front detector only.
REAR: Activates the rear detector only.
OFF: Activates neither the front nor rear detector.
Note
When set to OFF, the wireless Remote Commander
does not function. Use the keys on the control panel or
the wired Remote Commander.
INPUT-A
INPUT-A
GROUP INDEX
Groups multiple projectors or switchers to operate
them simultaneously.
GROUP INDEX: 0 1
You can set the group index number to the desired
number between 01 and 99.
DEVICE INDEX
Displays the index number set with the INDEX
switches on the rear of the projector. You can check
the device index number but cannot set it with this
menu.
SET SETTING
STATUS: ON
SPEAKER: ON
LANGUAGE: ENGLISH
INSTALLATION: FLOOR-FRONT
POWER SAVING: OFF
SIRCS RECEIVER: FRONT&REAR
GROUP INDEX: 0 1
DEVICE INDEX: 0 1
For details for setting the number, see page 36 (GB).
INPUT-A
31
(GB)