KitchenAid 860-0003 Instructions D'installation Et Guide D'utilisation Et D'entretien page 22

Change the Sear Burner orifice
1. Remove the screw securing the igniter and the 2 searing
side burner screws.
2. Lift out the searing side burner. 2. Lift out the searing side burner.
3. Locate the Liquid propane orifice at the end of the valve 3 Locate the Liquid propane orifice at the end of the valve
and use 6 mm socket wrench or 6 mm nut driver to
remove. Replace with natural gas orifice.
A. Orifice
22
IMPORTANT: Check that the orifice is properly installed
inside of the valve. Open the right door, check that the orifice
is properly installed inside of the burner venturi from the right
side door by using a flashlight.
4. Reinstall the searing side burner. Make sure that the
igniter is out of the way to allow proper positioning of
burner. Use Phillips screwdriver to attach the mounting
screws.
A.
5. Use Phillips screwdriver to reattach the igniter and
searing side burner plate.
6. Open the manual shutoff valve in the gas supply
line. The valve is open when the handle is parallel to the
gas pipe.
A. Orifice
A. Closed valve
B. Open valve
A.