KitchenAid 860-0003 Instructions D'installation Et Guide D'utilisation Et D'entretien page 21

Change the Rotisserie / Infrared Burner orifice
1. Use a Phillips screwdriver, unscrew the 2 screws and
remove the rotisserie/infrared burner wind baffle.
2. Using a Phillips screwdriver, remove the 6 screws at the
back of the grill from inside the grill. b k f th ill f i
3. Remove the access cover at the back of the grill
A.
A. Access cover
id th ill
hood.
4. Using a Phillips screwdriver, remove the 1 screw holding
the spider guard to the burner.
5. Use 24 mm wrench to remove the orifice nut.
A. Orifice nut
6. Take out the orifice support, and then use a 6 mm socket
and wrench or 6 mm nut driver to remove the LP orifice at
the end of the supply pipe. Replace with Natural gas
orifice.
A.
B
A. Orifice support A. Orifice support
B. Orifice
IMPORTANT: Check that the orifice is properly installed
inside of the supply pipe.
7. Reinstall the orifice support and supply pipe and tighten the
nut with a 24 mm wrench.
8. Reinstall the spider guard, access cover, and wind baffle.
A.
21