Recommended Charge Leads, Polarity; Controls, Using The Charger, Starting The Charge Process - GRAUPNER ULTRAMAT 16 S Instructions D'utilisation
Chargeur rapide à grande puissance piloté par micro-processeur pour la charge rapide, la décharge et le cyclage des accus nicd, nimh, lipo/liio/limn/life et des accus pb
Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Liability exclusion
As manufacturers, we at GRAUPNER are not in a position to ensure that you observe the
correct methods of operation when installing, using and maintaining this charger. For this reason
we are obliged to deny all liability for loss, damage or costs which are incurred due to the
incompetent or incorrect use and operation of our products, or which are connected with such
operation in any way.
4. Recommended charge leads /polarity
The requirements made on rechargeable batteries vary greatly according to their particular
application, and this in turn calls for different types of battery connector. Please note that
connectors, connector names and polarities may vary from one manufacturer to another. For
this reason we recommend that you always use genuine matching connectors of identical
construction. The following charge leads are suitable for battery charging with this unit:
Japan
Order No. 3371
G3.5 Order No. 2970.L
Be sure to use genuine charge leads fitted with cable of adequate conductor cross-section.
5. Charger controls / Using the charger / Starting the process
Screen
Connectors for
12...15V DC
power supply
or car battery
PC-Interface
BALANCER
CONNECTOR EH for
Graupner LiPo-battery
All the charger's functions are controlled by means of just four buttons.
The - / DEC and + / INC buttons are used to change the current and voltage values. The function
of the other two buttons varies according to the presence or otherwise of a battery at the charge
sockets:
Operating button
No battery
PROGRAMM/MODE
connected: PROGRAMM/MODE 2s.
ENTER/START
Battery
PROGRAMM/MODE
connected:
ENTER/START 2 sec.
G2 (AMP/G2,5)
Order No. 3011
Order No. 3037
-
Operating buttons
Function
Select charge programs and sub-groups
Select the (charge) program group
Select next position of a discharge/cycle adjustment
Ends the charge process, stops the buzzer,
Select next position of a discharge/cycle adjustment
Starts the charge process
BEC
Order No. 3021
JR
JR-Sender
Order No. 3022
fan
27
Publicité
Table des Matières
