Crown Moulding Cutting; Cutting Bowed Material; Clearing Jammed Material; Optional Evolution Accessories - Evolution R255 SMSL Notice Originale

CROWN MOULDING CUTTING

This machine is capable of cutting the
mitre angles required for Crown Mouldings.
To configure the machine to cut Crown
Moulding:
• Deploy the 33.9˚ Bevel Pin by pushing it fully
inwards. (Fig. 59)
• Tilt the cutting head to the 33.9˚ position
and lock it in place by tightening the bevel
lock handle.
• Turn the rotary table and set it to 31.6˚ mitre
angle as indicated by the protractor scale.
Ensure that the Crown Moulding is correctly
positioned on the rotary table and secure it with
appropriate clamps before making the cut.
When cutting operations are completed,
return the cutting head to the vertical position
and return the 33.9˚ Bevel Pin to its outer
(disengaged) position.
CUTTING BOWED MATERIAL (Fig. 63)
WARNING: Before cutting any work-piece, check
to see if it is bowed. If it is bowed the work-piece
must be positioned and cut as shown.
Do not position the work-piece incorrectly or cut
the work-piece without the support of the Fence.

CLEARING JAMMED MATERIAL

• Turn mitre saw "OFF" by releasing the
trigger switch.
• Allow the blade to come to a complete halt.
• Unplug the mitre saw from the mains supply.
• Carefully remove any jammed material from
the machine.
• Check the condition and operation of the
safety guard.
• Check for any other damage to any part of
the machine e.g. the blade.
• Have any damaged parts replaced by
a competent technician and a safety
inspection carried out before using the
machine again.
The free end of a long work-piece should be
supported at the same height as the machines
rotary table. The operator should consider
using a remote work-piece support stand,
adjustable workmate or saw horse etc.
www.evolutionpowertools.com

OPTIONAL EVOLUTION ACCESSORIES

DUST BAG (Supplied with R255SMS+)
A Dust Bag can be fitted to the extraction port
at the rear of the machine. The Dust Bag is for
use when cutting wooden materials only.
• Slide the Dust Bag over the dust extraction
port, ensuring that the spring clip grips the
port holding the Dust Bag securely in place.
(Fig. 64)
Note: For operational efficiency empty
the Dust Bag when it becomes 2/3 full.
Dispose of the contents of the Dust Bag in an
environmentally responsible way. It may be
necessary to wear a dust mask when emptying
the Dust Bag.
Note: A workshop vacuum extraction machine
can be attached to the dust extraction
port if required. Follow the manufacturers
instructions if such a machine is fitted.
WARNING: Do not use the Dust Bag when
cutting metallic materials including wood
with nails.
EXTRACTION PORT ADAPTOR
TUBE (Supplied with R255SMS+)
Use the Adaptor Tube to connect the
extraction port of the machine to suitable
commercial workshop vacuum extraction
equipment (not supplied) which have ø30mm
internal bore hoses or inlet ports.
32