Fitting And Removing The Blade; Attaching The Blade - Stihl RMA 460 Notice D'emploi

7 Assembling the Lawn Mower
1
► Open the side discharge shield (1) and hold it in position.
► Engage hooks (2) on the shaft (4) from below.
► Rest the side discharge shield (1) on the chute (3).
7.4.2 Removing the Chute
► Switch off the mower, remove the activation key and
battery.
► Place the mower on a flat surface.
1
► Open the side discharge shield (1) and hold it in position.
► Swing the chute (2) upwards and lift it away.
► Close the side discharge shield (1).
0458-796-9921-B
4
3
2
2
7.5

Fitting and Removing the Blade

7.5.1

Attaching the Blade

► Switch the lawn mower off, pull out the activation key and
remove the battery.
► Upend the lawn mower.
1
2
► Place new washer (1) on new bolt (2).
► Apply Loctite 243 or Loctite 242 thread locker to the
thread of bolt (2).
► Position blade (3) so the raised areas on the contact area
engage in the notches in blade (3).
3
2
4
► Screw in bolt (2) together with washer (1).
► Block blade (3) using a piece of wood (4).
► Tighten bolt (2) to 35 Nm.
English
3
15