Benelli IMPERIALE 400 Manuel Du Propriétaire page 113

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Instrument and control functions
Turn signal indicator lights "
"
"
Each indicator light will flash when its cor-
responding turn signal lights are flashing.
EN
Battery power indicator lamp
When the battery power is lower than
10.5V, the indicator lamp will light up.
3
Neutral indicator light "N"
This indicator light comes on when the
transmission is in the neutral position.
High beam indicator light "
This indicator light comes on when the
high beam of the headlight is switched
on.
Engine trouble warning light "
This warning light comes on if a problem
is detected in the engine or other vehicle
control system. If this occurs, have a Be-
nelli dealer check the on-board diagnostic
system.
The electrical circuit of the warning light
can be checked by turning the key to " ".
The warning light should come on for a
few seconds, and then go off.
If the warning light does not come on ini-
tially when the key is turned to " ", or if
" and
the warning light remains on, have a Be-
nelli dealer check the vehicle.
Tachometer
The tachometer shows the running tur-
nover of the engine so that the rider can
keep it within the ideal power range.
Function button "A"
Short press the button to switch betwe-
en TOTAL/TRIP1 and TRIP2.In TOTAL sta-
te,long press the button to enter time
adjusting mode .In TRIP state,long press
the button to reset the TRIP mileage.
"
Function button "B"
Short press the button to switch between
km/h and mph.
"
Digital clock
Shows the time in hours and minutes.
Fuel gauge
The digital fuel gauge shows the capacity
of the fuel tank. As the fuel level drops, the
lines on the gauge will become closer and
closer to the "E" reserve area.
As soon as the final line starts to lash, the-
re is an autonomy of about 3 litres of fuel.
Speedometer
Push and hold the menu switch "SELECT"
for 3 seconds to enter the setting mode
"TOTAL KM".
Speedometers Indicates the vehicle's spe-
ed in km/h or mph. To pass from one to
the other, press the "RESET" button.
Total/partial kilometre counter
Odometer records the total mileage dri-
ven, and Trip meter can be reset, which
records the mileages driven in a specific
period.
3 - 4

Hide quick links:

Publicité

Table des Matières
loading

Table des Matières