Saw Chain; Sharpening Your Chain And Adjusting Raker Clearance - Husqvarna 536LiPX Manuel D'utilisation

WARNING! Always stop the engine
!
before doing any work on the cutting
attachment. This continues to rotate even
after the throttle has been released.
Ensure that the cutting attachment has
stopped completely and disconnect the
spark plug cap before you start to work
on it.
Specification of bar and saw chain
When the cutting attachment supplied with your machine
has to be replaced, because it is worn out or damaged,
you must only fit the types of bar and saw chain
recommended by us.
Guide bar
• Length (inches/cm)
• Chain pitch (inches). The spacing between the drive
links of the chain must match the spacing of the teeth
on the bar tip sprocket and drive sprocket.
• Number of drive links. The number of drive links is
determined by the length of the bar, the chain pitch
and the number of teeth on the bar tip sprocket.
• Bar groove width (inches/mm). The groove in the bar
must match the width of the chain drive links.
GENERAL SAFETY PRECAUTIONS
• Lubrication hole and hole for the chain tensioner.

Saw chain

• Saw chain pitch (inches). (The distance between
three drive links, divided by two.)
• Drive link width (mm/inches)
• Number of drive links.
Level of kickback reduction. The only thing that describes
the level of kickback reduction offered by a saw chain is its
model number.
Sharpening your chain and adjusting
raker clearance
WARNING! The risk of kickback is
!
increased with a badly sharpened chain!
–
English 13