Etherma LAVA BATH 2.0 Instructions D'installation Et D'utilisation page 9

N O T E S
IMPORTANT NOTES:
› LAVA BATH infrared heating devices comply with the rele-
®
vant safety requirements.
› Installation and initial start-up, as well as repairs and servicing,
may be carried out by a licensed specialist or qualified individ-
ual only. All safety regulations must be observed. This person
must verify first whether the electrical in-house system
complies with the relevant standards. The responsibility of
the manufacturer is limited to supply of the device.
› Comply with country-specific safety regulations.
› Comply with local safety precautions.
› The devices are only suitable for vertical installation on walls.
S C O P E O F D E L I V E R Y | P A C K A G I N G
The LAVA ® BATH infrared heating must be mounted exclu-
sively using the fixing components included in the scope of
delivery.
STANDARD SCOPE OF DELIVERY FOR WALL MOUNTING:
› LAVA ® BATH 2.0 INFRARED HEATING
- 2 x mounting brackets
- 4 x hexagon bolts M8 x 16
- 1 x LAVA ® HALTI towel holder
C L E A R A N C E S
INSTALLATION AND MINIMUM DISTANCES:
LAVA BATH infrared heating devices have to be mounted so
®
that flammable objects cannot catch fire. Be absolutely sure
to comply with minimum clearances, in particular to highly
combustible objects such as curtains, upholstered furniture,
etc. Please also make sure that the infrared heater can radiate
freely into the room.
ATTENTION:
Strain of any kind on the surface,
whether from persons or objects leaning against it
or from other forces, must be avoided!
› Protective areas must be observed in accordance with DIN
VDE 0100, part 701, when installing the device in bathrooms.
› Minimum distances must be adhered to.
› In bathrooms, the device must be mounted so that switches
or other regulators cannot be touched by persons in a bath-
tub or shower.
› Due to the low surface temperature at the rear side (up to
40 °C) the infrared heating may also be mounted on wooden
panelling.
› The device is not intended for the use in wardrobes and
beneath church benches.
Screws and dowels (not included in the scope of delivery) must
correspond to the construction material of the wall (masonry,
concrete, plasterboard, etc.). The surface of the wall must be
even.
ATTENTION:
The wall must be even. Otherwise
damages on the surface of the LAVA
red heating device may occur.
35 mm
Dimensional drawing: minimum mounting clear-
ances
® BATH infra-
35 mm
35 mm
35 mm
9