Table Des Matières - Jonsered CS 2152 Manuel D'utilisation
Masquer les pouces
Voir aussi pour CS 2152:
- Manuel d'utilisation (124 pages) ,
- Manuel d'atelier (60 pages) ,
- Manuel d'utilisation (132 pages)
Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Before using a new saw
• Read the instructions carefully.
• Check cutting equipment is correctly fitted and adjusted.
See page 25.
• Refuel and start the saw. Check the carburetor settings.
See pages 26-29.
• Do not use the saw until sufficient chain oil has reached the
chain, see page 14.
IMPORTANT! If the carburetor mixture is too lean it greatly
increases the risk of engine failure.
Poor maintenance of the air filter will cause carbon build-up on
the spark plug and lead to difficult starting.
If the chain is badly adjusted it will cause increased wear or
damage to the bar, drive sprocket and chain.
Maintenance, replacement, or repair of the emission
control devices and systems may be performed by any
nonroad engine repair establishment or individual.
WARNING!
Under no circumstances may the design of
the machine be modified without the permis-
sion of the manufacturer. Always use genuine
spare parts/accessories. Non-authorized
modifications and/or accessories can result in
serious personal injury or the death of the
operator or others.
Your warranty may not cover damage or
liability caused by the use of non-authorized
accessories or replacement parts.
A chain saw is a dangerous tool if used care-
lessly or incorrectly and can cause serious,
even fatal injuries. It is very important that you
read and understand these instructions.
Warning! The inside of muffler contain
chemicals that may be carcenogenic. Avoid
contact with these elements in the event of
damaged muffler.
Long term inhalation of the engine's exhaust
fumes, chain oil mist and dust from sawdust
can represent a health risk.
When using a chain saw, a fire extinguisher
should be available.
Keep handles dry, clean and free of oil.
Beware of carbon monoxide poisoning.
Operate the chainsaw in well ventilated areas
only.
Do not attempt a pruning or limbing operation
in a standing tree unless specifically trained
to do so.
Jonsered has a policy of continuous product development and
therefore reserves the right to modify the design and
appearance of products without prior notice.
CONTENTS
Key to symbols
equipment ............................................................................ 8
What is what? .................................................................... 24
Mounting guide bar and chain ........................................... 25
Fuelmix .............................................................................. 26
Fuelling .............................................................................. 27
Start and stop .................................................................... 28
Carburetor ......................................................................... 29
Starter device .................................................................... 30
Air filter .............................................................................. 31
Spark plug ......................................................................... 31
Muffler ................................................................................ 31
Needle bearing maintenance ............................................ 31
Adjustment of the oil pump ................................................ 31
Cooling system .................................................................. 32
Heated handles (CS 2152 W) ........................................... 32
Winter use ......................................................................... 32
Daily maintenance ............................................................. 33
Weekly maintenance ......................................................... 33
Monthly maintenance ........................................................ 33
CS 2152 ............................................................................ 34
Your warranty rights and obligations ................................. 35
You will find the following labels on your chain saw:
EPA I:
EPA II:
The Emissions Compliance Period reffered to on the
Emissions Compliance label indicates the number of
operating hours for which the engine has been shown to
meet Federal emission requirements.
Category C = 50 hours, B = 125 hours, A = 300 hours.
Contents
...............................................................
............................................
................................................
................................................................
.........................................................
................................................
..............................................
2
4
4
10
16
18
19
3
English -
Publicité
Chapitres
Table des Matières
