Changing The Mains Fuse - Hofmann geodyna 7850p Mode D'emploi

2
1
140
1
3
6-8
6-9
Maintenance
WA R N I N G : B E F O R E AT T E M P I N G A N Y
MAINTENANCE OR REPAIRS, DISCONNET
THE ELECTRICAL POWER SUPPLY FROM THE
BALANCER.
6.4

Changing the mains fuse

Refer to Figure 6-8.
• Switch off the unit.
• Unplug the power cable from the power outlet.
• Remove the power cable from the machine mains
socket (1).
• Pull out the fuse holder (2).
• Replace the damaged fuse with another fuse having
an identical rating (3).
• Return the unit to its original functioning state, by
following the steps above in reverse.
6.5 Maintening the lift
Figure 6-9.
To clean the wheel lift, do not use liquids.
DO NOT SPILL LIQUID ON THE LIFT.
• Clean the lift with a dry cloth and compressed air.
• Check for too much play in the connecting parts.
DO NOT LUBRICATE THE HORIZONTAL
SLIDE RAILS (1, Fig. 6-9).
• Wipe with a cloth and lubricate the trapezoidal
thread screw. For that purpose, it is allowed only
the grease; RENOLIT GHT2 (P/N: 8-03329A).
• Grease the joints with an adequate quantity of
grease for mechanical applications. We recommend
using spry grease; not oil.
• If a fault occurs, stop using the equipment and call
the Snap-on technical support team.