Hofmann geodyna 7850p Mode D'emploi page 30

5 1 2
6
5 1 2
3
30
3 4
3 4
7 8
4-10
3 6 7
4 6
7
4-11
Layout
Fig. 4-10
Optimisation / Minimisation Screen.
Open with the OPT/MIN key (5, Fig. 4-7) when on the
Screen after a measuring run.
Commands available during the entire cycle:
1 - HELP key - Selects HELP texts relating to the
current function.
2 - BALANCING key - Opens the BALANCING Screen
Page.
3 - OPTIMISATION key - Starts the Optimisation cycle
4 - MINIMISATION key - Starts the Minimisation cycle.
5 - ESC key -
- Returns you to BALANCING/MAIN MENU.
6 - CONTINUE PREVIOUS OPT/MIN key - Continues
the previously interrupted Optimisation/Minimisation
cycle.
7 - CONFIRM key - Confirm / enter completed wheel
positioning, as required by the program.
8 - BACK key - Takes you back one step during
execution of the OPT/MIN program.
Fig. 4-11
Wheel Profile Screen Page.
Open with the SPECIAL key (3, Fig. 4-6), before the
measuring run.
Commands:
1 - HELP key - Selects HELP texts relating to the
current function.
2 - BALANCING key - Opens the BALANCING Screen
Page.
3 - SAVE key - Saves to the memory the wheel data
present in the "Current" line below the list.
4 - RETRIEVE WHEEL DATA key - Retrieves and sets
wheel data from one of the "Profile" items listed.
5 - ESC key -
- Returns you to the MAIN MENU.
4
- Exits C codes.
- Clears HELP texts and ERROR messages.
6 - PRINT key - For printing
7 - RIM DATA ENTRY key - To go to the Rim data
entry screen.
OPTIMISATION/MINIMISATION
WHEEL PROFILE