Hofmann geodyna 7850p Mode D'emploi page 122

8
A
8
8
122
5-60b
5-61
5-62
5-63
Operation
Figure 5-60b OPTIMISATION "10", outside
Rotate the wheel into marking position following the

arrows.
In this position make a double mark on the tyre

outer side exactly perpendicular to and above the
chuck.
Confirm by pressing key 8.

The OPTIMISATION "11" screen appears (Fig. 5-62).
Figure 5-61 OPTIMISATION "10", inside
If the wheel cannotbe turned over on the rim (e.g.:
Asymmetrical and Directional),
press key (A, Fig. 5-61), then

continue as shown on screen OPTIMISATION

"10" (Fig. 5-60b).
If the wheel can be turned over on the rim;
 Rotate the wheel into marking position following the
arrows.
 In this position make a double mark on the inside
of the tyre, exactly perpendicular to and above the
chuck.
 Turn the tyre over on the rim (tyre changer).
 Confirm by pressing key 8.
The OPTIMISATION "11" screen appears (Fig. 5-62).
Figure 5-62 OPTIMISATION "11"
Push the tyre on the rim until the double mark

coincides with the valve (use tyre changer).
Confirm by pressing key 8.

The OPTIMISATION "12" screen appears (Fig. 5-63).