Hitachi CR 18DV Instructions De Sécurité Et Mode D'emploi page 14

English
1. Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted into the receptacle, pilot lamp will
blink in red. (At 1-second intervals)
2. Insert the battery to the battery charger.
Battery
Pilot Lamp
3. Charging
When the battery is connected to the battery charger, charging will commence and the
pilot lamp will light in red. (See Table 2)
NOTE: If the pilot lamp flikers in red, pull out the plug from the receptacle and check if
the battery is properly mounted.
When the battery is fully charged, the pilot lamp will bilink in red slowly. (At 1-second
intervals) (See Table 2)
14
All manuals and user guides at all-guides.com
WARNING:
Do not use the electrical cord if damaged. Have it repaired
immediately.
Fig. 4
Insert the battery into the battery charger as
shown in Fig. 4. Make sure it contacts the bottom
of the battery charger.