Vetus EP2200E Manuel D'utilisation page 29

3 Operation
Do not allow the motor the run at full power for a long time when
still moored. The motor will not then reach its nominal speed and
will use a unnecessary amount of energy.
If the motor and/or the regulator becomes too hot due to overloading,
for example due to a plastic bag or rope in the propeller, the power will
be reduced until the motor or regulator has cooled down sufficiently.
If the above occurs, resolve the cause of the overloading at once.
c
aution
3 At the end of a cruise
• Turn the switch on the handle to the 'Off' position.
• Switch the (battery) main switch off.
With a on-board installed battery charger:
• Connect the battery charger to the dock electricity supply and check
that the batteries are being charged.
With a dock-side installed battery charger:
• Connect the batteries to the dock-side battery charger and check
that the batteries are being charged properly.
Always recharge the batteries after a cruise!
Cruising
n
ote
27