Projecting - Sony VPL-SC60U Mode D'emploi

Projecting

Projecting
LIGHT VOLUME
APA INPUT
APA key
MENU
RESET ENTER
22
(GB)
ON/STANDBY
indicator
I / u
ON 2
/STANDBY
POWER
SAVING
3
TEMP
/FAN
LAMP
/COVER
1
After all equipment is connected completely, plug the AC power cord
into the wall outlet.
The ON/STANDBY indicator lights in red and the projector goes into
the standby mode.
2
Press the I / u key on the Remote Commander or on the control panel.
The ON/STANDBY indicator lights in green.
3
Turn on equipment connected to the projector. Press the INPUT key on
the Remote Commander or on the control panel to select the input
source.
INPUT-A: Selects audio and video signals input from the INPUT A
VIDEO: Selects audio and video signals input from the video/audio
4
5
COMMAND I / u
OFF ON
MUTING
INPUT
AUDIO PICTURE
APA
APA key
MENU LASER
V
B b
ENTER R CLICK
v
RESET
VOLUME
+
–
connector.
input connector.
(If you connect to both the S VIDEO and VIDEO jacks, the
signal from the S VIDEO jack is selected.)
Rear remote control detector
1
Front remote control detector
2
3