Finalising The Installation; Connecting The Toilet; Securing The Toilet; Transport Safety Strap - Cinderella GAS Manuel D'installation

9. FINALISING THE INSTALLATION

9.1 CONNECTING THE TOILET

After you have finished installing the pipes, gently push the toilet
onto the outlet pipe. The toilet design allows the pipe to enter 35
mm onto the exhaust outlet before it stops. Do not force the pipe
into the toilet, as this may damage the toilet. Attach the ventilation
system to the appliance by connecting it to the fastners on the
back of the toilet.
Remember to plug in the 12V DC power supply before use. A green
light on the control panel will be lit when power is connected.

9.2 SECURING THE TOILET

In order to secure the Cinderella toilet to the floor:
1. Remove the ash container.
2. Mark the position of the holes on the floor. Remove the toilet.
3. Drill out the holes using an appropriate drill bit depending on the type
of floor. Use suitable screws.

9.3 TRANSPORT SAFETY STRAP

The ash container is equipped with a safety strap which must be removed before use:
1. Remove the front cover.
2. Cut away and remove the plastic straps attaching the ash container to the steel frame.

9.4 VERIFYING INSTALLATION

You can perform a simple performance test to ensure the system is functioning properly.
Performance test:
1. Lift the lid and seat – Red light should be lit and the fan starting to blow.
2. Simply insert an Original Cinderella Bowl Liner into the toilet.
3. Add water (1.2 litres) and toilet paper (1 metre)
4. Close the lid and push the start button – The yellow light should be lit. This indicates that the combustion
cycle has been activated).
5. The combustion cycle should take from 60–70 minutes before it starts to cool down.
6. Wait until the toilet has cooled down and the fan has stopped (this can take up to 60–90 minutes), check the
result in the ash container. You should only see white dust.
If the toilet failed to pass the performance test, please check that all the installation parameters are in
accordance with the manufacturer's instructions.
NOTE!
The performance test is designed to be performed when the toilet has not been used. Results may vary when
performing this test on used toilets.
13