Instructions For Use - Nilfisk Advance SR 1800C B-D Manuel D'utilisation

USER MANUAL
Without headlights
(See Fig. J)
1. Main broom control lever
2. Hopper control lever
3. Skirt control lever
4. Accelerator lever
5. Parking brake lever
6. Ignition switch
7. Horn switch
8. Hopper overheating buzzer (optional)
9. Fan control lever
10. Filter shaker switch
11. Brake pedal
12. Drive pedal
13. Warning light instrument panel
13a. Glow plug warning light
13b. Fuel warning light
13c. Battery charge indicator light
13d. Oil pressure warning light
13e. Coolant temperature warning light
13f. Engaged parking brake warning light
13g. High beam indicator light
13h. Running light indicator light
13i. Clogged air cleaner warning light
13j. Turn signal indicator light
13k. Hour counter
14. Fuse box B
15. Fuse box A
16. Optional switch
17. Side broom control lever
SR 1800C B
With headlights
(See Fig. K)
1. Main broom control lever
2. Hopper control lever
3. Skirt control lever
4. Battery plug
5. Parking brake lever
6. Ignition switch
7. Warning switch
8. Combination switch
9. Fan control lever
10. Filter shaker switch
11. Brake pedal
12. Drive pedal
13. Warning light instrument panel
14. Fuse box B
15. Fuse box A
16. Optional switch
17. Side broom control lever
18. Hopper overheating buzzer (optional)
10
Without headlights
(See Fig. L)
1. Main broom control lever
2. Hopper control lever
3. Skirt control lever
4. Battery plug
5. Parking brake lever
6. Ignition switch
7. Horn switch
8. Hopper overheating buzzer (optional)
9. Fan control lever
10. Filter shaker switch
11. Brake pedal
12. Drive pedal
13. Warning light instrument panel
14. Fuse box B
15. Fuse box A
16. Optional switch
17. Side broom control lever
Controls and levers
The control levers are used for the following functions:
– Side broom lifting;
– Hopper lowering;
– Hopper lifting;
– Side broom lowering;
– Skirt opening;
– Skirt closing;
– Main broom lowering;
– Main broom lifting.

INSTRUCTIONS FOR USE

Start (SR 1800C D)
NOTE
Machines with the EC marking are provided
with safety devices should the operator leave
the driver's seat.
The machine cannot be started unless the
operator is sitting in position.
– Before starting the machine, make sure the parking
brake (5, Fig. I) is engaged.
– Insert the ignition key in the ignition switch.
– Turn the accelerator lever (4, Fig. I) to idle.
– Turn the ignition key clockwise to the first position.
Battery charge and oil pressure warning lights should be
on.
– The glow-plug pre-heating warning light goes off: Turn
the ignition key clockwise until the end of stroke. When
the motor is on, release the ignition key which will
automatically return to the first position.
NOTE
Before trying to start the machine again, turn
the ignition key back to "0" position.
As soon as the machine has been started,
check the battery charge, oil pressure and
pre-heating warning lights are off.
33014817(2)2006-06 A