Instructions For Use; Machine Use - Nilfisk SWEEPER SR 1450 B-D Manuel D'utilisation

USER MANUAL

INSTRUCTIONS FOR USE

Start (SR 1450 D)
NOTE
Machines with the EC marking are provided
with safety devices should the operator leave
the driver's seat.
The machine cannot be started unless the
operator is sitting in position.
– Before starting the machine, make sure the parking
brake (5, Fig. I) is engaged.
– Insert the ignition key in the ignition switch.
– Turn the accelerator lever (4, Fig. I) to idle.
– Turn the ignition key clockwise to the first position.
Battery charge, oil pressure and glow plug pre-heating
warning lights should be on.
– The glow-plug pre-heating warning light goes off: turn
the ignition key clockwise until the position "Engine start"
is reached. When the engine is on, release the key which
will automatically return to the first position.
NOTE
Before trying to start the machine again, turn
the ignition key back to "0" position.
As soon as the machine has been started,
check the battery charge, oil pressure and
pre-heating warning lights are off.
Stop (SR 1450 D)
Turn the ignition key counterclockwise to "0" position and then
remove it. Pull the parking brake lever.
Start (SR 1450 B)
– Before starting the machine, make sure the parking
brake (5, Fig. J) is engaged.
– Connect the battery cable socket with the machine cable
plug.
– Be sure of the perfect connection.
– Insert the ignition key in the ignition switch.
– Turn the ignition key clockwise to the first position. The
battery charge indicator light should be on.
– Turn the ignition key clockwise until "Engine start"
position is reached. When the engine is on, release the
ignition key which will automatically return to the first
position.
NOTE
Before trying to start the machine again, turn
the ignition key back to "0" position.
As soon as the machine has been started,
check the battery charge and oil pressure
warning lights are off.
Stop (SR 1450 B)
Turn the ignition key counterclockwise to "0" position and then
remove it. Pull the parking brake lever.
10

MACHINE USE

Waste collection (SR 1450 D)
– Turn the accelerator lever to the maximum speed
position.
– Press the switch to operate the suction fan.
– Skirt opening: push the distributor lever.
– Make sure that the skirt closing panel is completely
open.
– To start and lower the main and side brooms, push the
distributor lever.
– Pull the lever to use only the main broom.
When necessary, dump the hopper as follows:
– Lift the main and side brooms.
– Switch off the fan by pressing the push-button.
– Close the skirt.
– Drive the machine to the appointed dumping area.
– Lift the hopper to the correct dumping height.
– Open the skirt.
– Lower the hopper.
– Close the skirt.
– Activate the filter shaker for approx. 20 seconds.
– Stop the brooms by moving the central lever back to the
central position.
– Pull the lever to lift the main and side brooms.
– Pull the lever to close the skirt.
– Press the switch to stop the fan.
– Push the lever to lift the hopper to the required dumping
height.
WARNING!
Move the machine extremely slowly when the
hopper is in the lifted position.
Maximum speed 1 km/h.
Do not dump the hopper with the machine on a
slope.
– Open the skirt by pushing the lever to dump the hopper.
WARNING!
When dumping the hopper, make sure that
nobody is near the machine.
– Pull the distributor lever to lower the hopper.
– Pull the lever to close the skirt.
– After dumping and with the hopper in the lowered
position, activate the filter shaker for approx. 20 seconds
by pressing the relevant push-button.
WARNING!
Do not activate the filter shaker with the hopper
in the lifted position.
33014811(1)2005-07 A