Table des Matières
Publicité
Instructions for Starting the Walk-Behind Sweeper
Before starting the walk-behind sweeper, perform the following checks:
1
The battery water level.
2
Lift the side broom by lever 2, figure 1.
Motor start-up:
1
Insert the starting key 6, figure 1 and turn it clockwise, to power up the motor.
Operations for starting the walk-behind sweeper:
1
Advancing: The driving system is engaged by pushing handle 1 (fig. 2). Wheel 2 moves forward and pushes on roller 3, activating the
rear wheels by chain 4.
The distance between roller 3 and wheel 2 with the drive system disengaged must be about 3/64-5/64" (1-2 mm). This distance can be regulated
by adjusting screw 5.
Instructions for Operating the Walk-Behind Sweeper
1
Do not pick up burning cigarette debris or other hot cinder ash type objects.
2
Avoid picking up pieces of string, wire, packing straps, and water, etc..
3
To pick up large but light objects (such as paper, leaves, etc.), pull up on the front flap lifting handle 5 (fig 1) so the debris enters the broom
housing.
4
Every 15-20 minutes of operation clean the panel filter by pushing the shaker button 7 (fig 1) for 10-15 seconds.
5
When working on a wet floor, shut off the suction by means of knob 3, figure 1 to prevent water from being sucked up and clogging the
filters.
Fig. 2 - Drive Control Scheme
1
Drive Control Lever
2
Drive Wheel
3
Drive Roller
4
Rear Control Chain
5
Drive Linkage Adjustment
Abb. 2 - Antriebssystem
1
Antriebssteuerhebel
2
Antriebssteuerrad
3
Antriebsrolle
4
Antriebssteuerkette
5
Einstellschraube antriebskabel
Fig. 2 - Schéma Commande Traction
1
Levier commande traction
2
Roue de commande traction
3
Rouleau traction
4
Chaîne de commande traction
5
Réglage câble traction
Fig. 2 - Esquema mando tracción
1
Palanca mando tracción
2
Rueda mando tracción
3
Rodillo tracción
4
Correa de mando tracción
5
Regulador cable tracción
11 - FORM NO. 041324 / RETRIEVER 350B
1
Publicité
Table des Matières
Dépannage
