Assembly - Husqvarna RA-V Manuel D'utilisation

• Around stones and trees.
• Near water.
To install the cutting unit
Note: The cutting attachment must only be installed to a
grass trimmer. Refer to
WARNING: Use protective gloves when you
hold the blades.
1. Remove the clamp screw from the gear housing.
1051 - 001 - 18.04.2019
Intended use on page 2 .

Assembly

2. Put the shaft (B) into the gear housing (A). Make
sure that the drive shaft engages in the gear
housing.
3. Install the clamp (C) and tighten the lock screw (D).
Install the clamp screw (E) for the gear housing and
tighten it.
C
E
CAUTION: Do not put the gear housing
in water.
B
A
CAUTION: Make sure that the holes are
aligned. If the holes are not aligned, the
gear housing can be damaged.
D
7