Husqvarna RA-V Manuel D'utilisation page 10

2. Remove the 4 screws (D), the lower blade (E) and
the shim (F).
3. Remove the 4 screws (G) and the top blade (H).
4. Install the blades in opposite sequence. Tighten the
screws equally when you install the blades.
5. Torque the screws (G) to 9-12 Nm.
6. Torque the screws (D) to 9-12 Nm.
7. Torque the center screw (A) to 15-20 Nm.
10
To adjust the clearance between the
blades
D
1. Remove the lower blade, refer to
E
2. Remove the shim.
F
3. Install the lower blade. Tighten the screws equally
To replace the cutting attachment
guard
G
H
•
•
WARNING: Use protective gloves when you
hold the blades.
blades on page 9 .
Note: Save the shim until it is time to replace the
blades.
when you install the blades.
WARNING: Use protective gloves when you
hold the blades
Remove the 2 screws (B) and the cutting attachment
guard (A).
Install the new cutting attachment guard (A) with the
2 screws (B). Tighten the screws equally.
B
To replace the
A
1051 - 001 - 18.04.2019