Setting The Time And Date Manually - ADE WS 1601 Mode D'emploi

‚ You can start the receiving process again manually,
see "Starting signal reception manually", or
‚ Wait until the base station automatically switches
to receiving mode again at a later point in time. The
reception is usually better at night.
‚ If reception is not possible at your location, you can
set the time and date manually, see next chapter.

Setting the time and date manually

If there is more than approx. 20 seconds between
two pushes of a button, the setting process auto-
matically ends and you will have to repeat it.
1. Press and hold the MODE button until the temperature
unit (°C or °F) blinks on the display.
2. Using the
3. Press MODE to save the setting. The time format blinks
on the display („24 Hr" or „12 Hr").
4. Proceed as previously described.
5. Press MODE each time to save the settings.
6. Press the
7. Carry out the following settings:
− Time zone in which you are located (for most
countries in Europe, 00 is the correct setting for the
time zone)
− Hours
− Minutes
− Weather symbol
8. Finally, press MODE to conclude the procedure.
Weather Station with Wireless Outdoor Sensor WS 1601
or button, set the desired unit.
or button to set the desired value.
53