Husqvarna 535LK Manuel D'utilisation page 10

To assemble the loop handle
1. Attach the loop handle onto the shaft between the
arrows.
2. Move the spacer into the slot of the loop handle.
3. Attach the nut, the knob and the screw, do not make
it to tight.
4. Adjust the product to a comfortable position.
5. Tighten the bolt.
To assemble the two-piece shaft
1. Turn the knob to loosen the coupling.
2. Align the tab of the cutting attachment (A) with the
arrow of the coupling (B).
B
3. Carefully push the shaft into the coupling until you
hear a click.
10
4. Tighten the knob fully.
To disassemble the two-piece shaft
1. Turn the knob 3 turns or more to loosen the
2. Push and hold the button (C).
3. Hold tight in the end of the shaft that the engine is
4. Pull the attachment straight out of the coupling.
A
To assemble the cutting attachment guard and
trimmer head
1. Attach the correct cutting attachment guard (A) for
2. Put the cutting attachment guard onto the fitting on
coupling.
attached to.
C
the trimmer head. Refer to
the shaft.
Accessories on page 21 .
331 - 009 - 30.01.2021