Setting Up; Preparing The Remote Control; Setting Up The Remote- Controlled Socket - SilverCrest IAN 276299 Instructions D'utilisation Et Consignes De Sécurité

Safety / Setting up
only be carried out by the service
department or a specialist electrical
workshop.
J
Before cleaning always disconnect
the device from the mains supply. In
this case always remove the radio-
controlled electrical outlet socket
from the mains wall socket and
remove all plugs from the device.
J
Do not have one radio-controlled
electrical outlet socket inserted
behind the other.
J
Do not use any additional child
protection devices for the radio-
controlled sockets. The connection
between the plug and the radio-
controlled socket could be impaired
and risk from overheating then arises.
The radio-controlled sockets already
have a child protection device which
prevents children from putting any
objects into the socket.
J
Ensure that the outlet is installed
close to the connected product, is
easily accessible and that the prod-
uct is not operated while covered.
J
If the device malfunctions, switch it
off immediately.
J
These instructions are a component
of the device. If you pass the device
on to a third party, these instructions
must also be handed on.
Do not switch the wireless sockets
erratically or unattended.
26 GB

Setting up

Q
Preparing the remote
Q
control (fig. A)
1. Open the battery compartment on
the back of the remote control by
turning the battery cover to the left
with a coin or a screwdriver. Insert
the button cell. Ensure correct
polarity (+ = up).
2. Press one of the ON/OFF buttons
or to verify the remote con-
2 3
trol is working; if so, the operating
control lamp
1
Setting up the remote-
Q
controlled socket
1. Plug the remote-controlled socket
into an earthed household socket.
2. The LED operating status display
will now flash slowly for approx.
30 seconds after plugging in.
3. Aim the remote control at the
remote-controlled socket at a
distance of approx. 50 cm.
4. With the LED operating status dis-
play flashing, press the desired
5
ON button of the channel ON /
OFF button
2
the remote control. The LED operat-
ing status display
continuously. You can now use the
remote control to switch a con-
nected device on or off using.
5. Repeat this process with the other
wireless sockets.
will light up.
5
(A, B, C or D) on
will now light
5