Bosch PSS 300 AE Notice Originale page 17

OBJ_BUCH-62-002.book Page 17 Monday, December 3, 2007 12:54 PM
The vacuum cleaner must be suitable for the ma-
terial being worked.
When vacuuming dry dust that is especially detri-
mental to health or carcinogenic, use a special
vacuum cleaner.
Replacing the Sanding Sheet
When attaching a new sanding sheet, remove any
dust or debris from the sanding plate 5 (e. g. with
a brush).
To ensure optimum dust extraction, pay atten-
tion that the punched holes in the sanding sheet
match with the holes in the sanding plate.
Sanding Sheets with Velcro Backing
(see figure A)
The sanding plate 5 is fitted with Velcro backing
for quick and easy fastening of sanding sheets
with Velcro adhesion.
Before attaching the sanding sheet 6, free the
Velcro backing of the sanding plate 5 from any
debris by tapping against it in order to enable op-
timum adhesion.
Position the sanding sheet 6 flush alongside one
edge of the sanding plate 5, then lay the sanding
sheet onto the sanding plate and press it against
it with a light turning motion in clockwise direc-
tion.
To remove the sanding sheet 6, grasp it at one of
the tips and pull it off from the sanding plate 5.
Sanding Sheets without Velcro Backing
(see figure B)
Lightly lift and unlatch the sanding-sheet clamp
4.
Guide the sanding sheet 6 under the opened rear
sanding-sheet clamp 4 to the stop and clamp the
sanding sheet by reinserting the sanding-sheet
clamp 4.
Fold the sanding sheet 6 firmly around the sand-
ing plate. Guide the other end of the sanding
sheet 6 under the front sanding-sheet clamp 4
and clamp the sanding sheet by reinserting the
sanding-sheet clamp 4.
Bosch Power Tools
Sanding sheets without holes, e. g. from rolls or
by the meter, can be punctured with the perfo-
rating tool 10 for use with dust extraction. For
this, press the machine with the mounted sand-
ing sheet onto the perforating tool (see figure E).
To remove the sanding sheet 6, unlatch the sand-
ing-sheet clamp 4 and pull out the sanding sheet.
Selecting the Sanding Sheet
Depending on the material to be worked and the
required rate of material removal, different sand-
ing sheets are available:
Grain size
For the working of all
wooden materials
For coarse-sanding,
e. g. of rough, un-
planed beams and
boards coarse
For face sanding and
planing small irregu-
larities medium 80, 100, 120
For finish and fine
sanding of hard
woods fine
For the working of
paint/enamel coats
or primers and fillers
For sanding off paint coarse
For sanding primer medium 80, 100, 120
For final sanding of
primers before coat-
ing fine
Replacing the Sanding Plate
The sanding plate 5 can be replaced, if required.
Unscrew the 6 screws 11 completely and remove
the sanding plate 5. Attach the new sanding plate
5 and tighten the screws again.
English | 17
40 — 240
40, 60
180, 240
40 — 320
40, 60
180, 240, 320
1 609 929 N23 | (3.12.07)