Parts For Assembly & Installation; Seat Assembly - Diono Cambria 2 Manuel D'instructions

PARTS FOR ASSEMBLY & INSTALLATION
1
2
5
12
1-866-954-9786
1. Head Support Adjuster
2. Upper Belt Guide
3. Lower Belt Guide
4. UAS Adjuster Straps
5. UAS Connectors
6. Cup Holder
4
3
6
ATTACHING THE BACKREST
1. With seat lying flat on the floor, tuck in fabric panel
at rear of seat. Place hooks at seat bottom as shown.
1
2. Attach the backrest hooks to seat mounting points.
2
3. Push down on seatback just above hooks until
fully engaged.
3
4. Rotate seatback to an upright position while
maintaining pressure just above the hooks. Finish by
tucking any excess fabric up and under the fabric of
the backrest.
4
ca.diono.com

SEAT ASSEMBLY

13