Seat Assembly; Attaching The Backrest - Diono cambria 2 Manuel D'instructions

SEAT ASSEMBLY

ATTACHING THE BACKREST

1. With seat lying flat on the floor, tuck in fabric
panel at rear of seat. Place hooks at seat bottom
as shown.
2. Attach the backrest hooks to seat mounting
points.
3. Push down on seat back just above hooks until
fully engaged.
4. Rotate seat back to an upright position while
maintaining pressure just above the hooks. Finish
by tucking any excess fabric up and under the
fabric of the backrest.
14
1-866-954-9786
WARNING!
cause serious injury in an accident. If your vehicle is equipped with
lower anchors, Diono always recommends installation utilizing the UAS
connectors with this booster seat.
To improve safety and performance, this booster seat is equipped
1
with a lower anchorage system that allows secure
attachment to a vehicle's lower anchor locations.
1. Disengage UAS connectors from storage slots
and lay booster seat on its side. While depressing
the cam lock lever, gently pull UAS connectors
away from the booster seat and extend both
2
straps. Do not overextend connector straps.
2. Attach both UAS connectors to the vehicle
anchors, starting with the connector that is
furthest from you. For ease of use, make sure
open end of hooks face upward during use.
3. While pushing booster against vehicle seat,
3
pull one adjuster strap tight and then the other.
Make sure that both UAS connectors are securely
attached to the vehicles lower anchors.
NOTE:
and adjusted, child seat will still have movement
against the vehicle seat back and bottom.
4
Unsecured objects can become flying hazards and can
Even with UAS connectors properly attached
diono.com
INSTALLATION
1
2
3
15