Backless Booster Seat - Diono cambria 2 Manuel D'instructions

SECURING THE CHILD
PROPER BUCKLE POSITION
IMPORTANT: After booster seat is installed and seat belt is fastened
around child, it is important to confirm correct seat belt buckle position to
ensure secure installation.
CORRECT SEAT BUCKLE
POSITION
Buckle is on the outside of
lower belt guide.
20
1-866-954-9786
INCORRECT SEAT BUCKLE
POSITION
If buckle is being pulled
across the lower belt guide
and into the seat, choose
another seating position
within the vehicle.
While this booster seat is designed to offer advanced side-impact
protection with its backrest section attached, the seat bottom can also be
used alone as a backless booster.
1. Remove the seat back by reversing the steps shown in "Seat Assembly."
2. Make sure both UAS connectors are securely attached to the vehicles
lower anchors (see "Lower Anchor Installation"). While pushing
booster against vehicle seat, pull the adjuster straps tight.
3. Place booster seat on vehicle seat so it is resting
firmly on vehicle seat bottom and touching the
vehicle seat back. The entire seat bottom should sit
flat on the vehicle seat.
4. Properly position child: sitting upright and all the
way back in the booster seat.
5. Fasten seat belt across child.
6. Make sure seat belt is not twisted and lays flat
across child's hips, torso and shoulder.
7. Tighten the seat belt by pulling the diagonal shoulder
belt portion in the direction of the arrows.
NEVER position the shoulder belt loosely or under the child's arm or
behind their back.

BACKLESS BOOSTER SEAT

BACKLESS BOOSTER MODE FOR USCA
diono.com
21