Securing The Child - Diono Cambria 2 Manuel D'instructions

SECURING THE CHILD

1. Place booster seat on vehicle seat so it is resting
firmly on vehicle seat bottom and touching the vehicle
seat back. A gap is acceptable as long as the head
support is touching the vehicle seat back or head rest.
2. Properly position child: sitting upright and seated
all the way back in the booster seat.
3. Adjust head support to proper height: The RED
shoulder belt guide should be slightly above the
child's shoulders (at least 1 cm). Squeeze the head
support adjustment lever on the back of the booster
seat while adjusting it's height up or down to fit the
child.
4. Feed the vehicle diagonal shoulder belt portion of
the seat belt through the RED shoulder belt guide
into the side of the seat opposite the seat belt buckle.
5. Fasten vehicle seat belt across child. The lap
portion of the seat belt should rest within both lower
belt guides. The diagonal shoulder belt portion should
route inside the lower belt guide closest to the buckle
and over child's shoulder.
16
1-866-954-9786
6. Make sure the vehicle seat belt is not twisted and lays flat across child's
lap, torso and shoulder.
7. Tighten the seat belt by pulling the diagonal
shoulder belt portion in the direction of the arrows.
8. Confirm seat belt buckle is in correct position.
IMPORTANT: The Vehicle Shoulder Belt MUST route
completely through the RED shoulder belt guide and
not fall off the child's shoulder.
IMPORTANT: DO NOT position the Vehicle Lap Belt over the armrest.
It MUST pass under the armrest.
IMPORTANT: When using the diagonal portion of the seat belt, it should
lay over the shoulder and should NOT be touching the child's neck.
IMPORTANT: When using booster seat in center seating position, make
sure it is stable and does not rock from side to side.
ca.diono.com
SECURING THE CHILD
17