Securing The Child - Diono Monterey XT 10800 Serie Manuel D'instructions

Securing the Child

1) Make sure booster seat is properly positioned and installed on
vehicle seat as per the instructions in pages 7–9 and 11–13.
2) Properly position child: sitting upright and all the way back in
the booster seat.
3) Make sure booster seat backrest width is adjusted to narrowest
width setting that comfortably fits child (see page 11).
4) Raise the headrest to access red upper belt guides.
diagonal portion of the seatbelt through the guide on the side
opposite the seatbelt buckle.
5) Fasten seatbelt across child: Lap portion of seatbelt should rest
within both lower belt guides. Diagonal shoulder portion should
route inside the lower belt guide closest to the buckle and over
child's shoulder.
6) Adjust headrest (page 11) to proper height: Upper shoulder
guide should be slightly above (at least 1 cm) the child's
shoulders.
WARNING: If headrest is adjusted to maximum height and child's
shoulder height is closer than 1 cm to the upper belt guide, child is
too tall and the seat can only be used a backless booster.
A
Feed the
14