EINHELL TC-RS 38 E Mode D'emploi D'origine page 15

Danger!
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level ........................ 84 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level .......................... 95 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
Wear ear-muff s.
The impact of noise can cause damage to hea-
ring.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 60745.
Handle
Vibration emission value a
K uncertainty = 1.5 m/s
The specifi ed vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equip-
ment is used and may exceed the specifi ed value
in exceptional circumstances.
The specifi ed vibration value can be used to
compare the equipment with other electric power
tools.
The specifi ed vibration value can be used for initi-
al assessment of a harmful eff ect.
Keep the noise emissions and vibrations to a
minimum.
•
Only use appliances which are in perfect wor-
king order.
•
Service and clean the appliance regularly.
•
Adapt your working style to suit the appliance.
•
Do not overload the appliance.
•
Have the appliance serviced whenever ne-
cessary.
•
Switch the appliance off when it is not in use.
•
Wear protective gloves.
Anl_TC_RS_38_E_SPK1.indb 15 Anl_TC_RS_38_E_SPK1.indb 15
= 10.223 m/s
2
h
2
- 15 -
GB
Caution!
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain resi-
dual risks cannot be rules out. The following
hazards may arise in connection with the
equipment's construction and layout:
1. Lung damage if no suitable protective dust
mask is used.
2. Damage to hearing if no suitable ear protec-
tion is used.
3. Health damage caused by hand-arm vib-
rations if the equipment is used over a pro-
longed period or is not properly guided and
maintained.
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
5.1 Fitting the dust bag (Fig. 2)
Place the dust bag (6) on the dust bag connector
(5) and secure it by turning it.
The dust is extracted directly through the grin-
ding/sanding paper and the grinding/sanding disk
and into the dust bag.
Caution!
For health safety reasons it is imperative that you
use a dust bag.
5.2 Fastening the abrasive paper (Fig. 5)
Easy replacement using Velcro fastening. Ensure
that the extractor holes on the abrasive paper and
grinding/sanding disc line up.
24.07.14 09:09 24.07.14 09:09