Computer Instructions - Christopeit Sport X1 Bike Notice De Montage Et D'utilisation

Computer instructions for 1401
The supplied computer allows the most convenient training. Every value
relevant to training is displayed in a corresponding window.
From the beginning of the training session, the required time, the current
speed, the approximate calorie consumption, the travelled distance ad the
current pulse rate are displayed. All values are counted from zero upwards.
The speed is indicated on the upper display. All other values are indicated
on the lower display.
If you wish to see one value displayed constantly as well as the speed
during training, select this with the „F" key. If you wish to see these values in
constant alternation, select the „SCAN" function. The display then changes
from one function to the next at intervals of approx. 6 seconds.
The computer is switched on by briefly pressing the F- key or simply by
beginning training. The computer begins to register and display all values.
To stop the computer, just stop training. The computer stops all
measurements and retains the last attained values. The last attained values in
the functions TIME, CALORIES and KM are stored and training can continue
with these values when training is resumed.
The computer switches of automatically approx. 4 minutes after training
is stopped. All values attained until that time are stored and are displayed
again when training is resumed. It is then possible to continue training from
these values.
Displays:
1. „SPEED" (SPD) display:
The current speed is displayed in kilometres per hour. The values last attained
by this function are not stored. (Limit of the display: 99.9 km/h.)
2. „TIME" (TMR) display:
The currently required time is displayed in minutes and seconds. The values
last attained by this function are stored. (Limit of the display: 99.59 minutes.)
3. „DIST (DST)" display:
The current status of the travelled distance is displayed. The values last
attained by this function are stored. (Limit of the display: 999,9 km.)
4. „CALORY" (CAL) display:
The current status of the consumed calories is displayed. The values last
attained by this function are stored. (Limit of the display: 9999 calories.)
5. „PULSE" display:
The current pulse rate is displayed in beats per minute. The values last
attained by this function are not stored. (Limit of both displays: 40 – 240
pulse beats per minute.)
Note:
For pulse measurement, the two contact surfaces of the pulse measuring
handle unit must be gripped simultaneously. The contact surfaces should
be located centrally in the palms of the hands.
6. „SCAN" function:
If this function is selected, the current values of all functions are displayed
successively in a constant sequence approx. every 5 seconds.
Keys:
1. „F" key:
Pressing this key once briefly makes it possible to change from one function
to another, i.e. the respective functions can be selected. The currently
selected function is indicated by an icon in the respective window. If the
key is held longer (approx. 3 seconds), all last attained values are deleted.
AA batteries
Replacing the batteries:
1. Open the battery compartment cover and then remove the used Batteries.
(If the batteries should leak remove them under increased considering that
the battery acid is not into contact with skin come and clean the battery
compartment thoroughly.)
2. Insert the new batteries (type (AA) 1.5 V in the correct order and taking
into account the polarity in the battery compartment and close the battery
cover so that it clicks into place.
3. If the computer does not pick up immediately, the function should Batteries
are removed for 10 seconds and re-inserted.
4. The empty batteries properly in accordance with the disposal regulations
disposed of and do not give residual waste.
22
Battery compartment