Christopeit Sport X1 Bike Notice De Montage Et D'utilisation page 18

Step 3:
Installation of the computer (8) at handlebar (5).
1. Take the computer (8) that has been supplied out of the
packaging and insert the batteries (Type "AA"-1.5 V pencells) by
watching for the right polarity on the back of the computer (8).
(Batteries for the computer are not included in this item. Please
buy them at your located market.)
2. Guide the computer (8) to the middle of the handlebar (5) and
connect the plugs of connection cable (14) and pulse cables (11)
with computer (8).
3. Push the computer (8) onto the computer holder at handlebar
(5).
Step 4:
Installation of right and left pedal (7LR+7R) at pedal crank
(6L+6R).
1. The pedals are marked "R" for right and "L" for left.
2. Screw the right pedal (7R) into the threaded hole on the right
hand side of the pedal crank (6R) and tighten firmly.
(Note: Right and left are specifies as viewed seated on the
machine during training. It must also be observed that the
threaded part of the right pedal must be screwed clockwise into
the threaded hole of the pedal crank.)
3. Screw the left pedal (7L) into the threaded hole on the left hand
side of the pedal crank (6L) and tighten firmly.
(Note: The threaded part of the left pedal have to screw
anticlockwise into the threaded hole of the pedal crank.)
18