GreenWorks 2101202CT Manuel Du Propriétaire page 16

OPERATION
LOCK-OUT BUTTON (See Figure 9.)
The lock-out button reduces the possibility of accidental starting. The lock-out button is located
on the handle above the switch trigger. The lock-out button must be depressed before you pull
the switch trigger. The lock resets each time the trigger is released.
STARTINg AND STOPPINg THE TRImmER (See Figure 9.)
To start:
• Press the power button.
• Depress the lock-out button and squeeze the switch trigger.
• Press high speed button to increase speed depending upon grass condition. Two LED's will
illuminate above the high speed button indicating that the trimmer is in the high speed setting.
To stop:
• Release the switch trigger.
• Press the power button again to turn the unit off.
Note: The unit will power itself down after being idle for 1 minute.
OPERATINg THE TRImmER (See Figure 10.)
Hold the power head with your right hand on the rear handle and your left hand on the auxiliary
handle. Keep a firm grip with both hands while in operation. Power head should be held at a
comfortable position with the rear handle about hip height.
Always operate power head at full throttle. If debris becomes wrapped around the attachment,
release the switch trigger, and remove the debris.
HIgH/LOW SPEED
BUTTON
ON/OFF
BUTTON
16
Fig. 9