GreenWorks 2101202CT Manuel Du Propriétaire page 12

ASSEMBLY
INSTALLINg AN ATTACHmENT TO THE POWER HEAD (See Figure 4.)
W A R N I N g
Read and understand entire Operator's Manual for each optional attachment used on this power
head and follow all warnings and instructions. failure to follow all instructions may result in electric
shock, fire and/or serious personal injury.
W A R N I N g
Never install, remove, or adjust any attachment while power head is running. Failure to stop the
motor can cause serious personal injury. Never operate power head without an attachment.
Attachment compatibilities
This 80-Volt powerhead is compatible with universal gas attachments.
NOTE: When using string trimmer attachments, use only .080 in. diameter line.
The attachment connects to the power head by means of a coupler device.
• Loosen the attachment knob on the coupler.
• Push in the release button located on the attachment shaft. Align the button with the guide
recess on the power head coupler and slide the two shafts together. Rotate the attachment
shaft until the button locks into the positioning hole.
NOTE: If the button does not release completely in the positioning hole, the shafts are not locked
into place. Slightly rotate from side to side until the button is locked into place.
• Tighten the attachment knob securely.
REmOVINg THE ATTACHmENT FROm THE POWER HEAD
for removing or changing the attachment:
• Stop the power head.
• Remove the battery from the power head.
• Loosen the attachment knob.
• Push in the release button and twist the shafts to remove and seperate ends.
POSITIONINg HOLE
RELEASE BUTTON
ATTACTHmENT
SHAFT
12
ATTACHmENT KNOB
Fig. 4