GreenWorks 2101202CT Manuel Du Propriétaire page 14

ASSEMBLY
ADJUSTINg THE CUTTINg SWATH (See Figure 7.)
The trimmer is currently set at a 14 in. cutting swath. To adjust to a cutting swath of 16 in.:
• Remove the battery from the string trimmer.
• Remove both screws on the cut-off blade with a Phillips screwdriver (not included).
• Rotate the cut-off blade 180°.
• Replace both screws in the cut-off blade.
Note: Set the cut-off blade to 14 in. for greater runtime. Set the cut-off blade to 16 in. for greater
cutting area.
180
ATTACHINg A SHOULDER HARNESS (See Figure 8.)
• Rotate the harness holder to the upward position.
• Hook a shoulder harness to the harness holder.
HARNESS
HOLDER
14
CUT-OFF BLADE
Fig. 7
Fig. 8