Publicité
Les langues disponibles
Les langues disponibles
Installing or removing flex wheel
Optional accessory
WARNING:
Always use supplied guard when
flex wheel is on tool. Wheel can shatter during use
and guard helps to reduce chances of personal injury.
2
3
4
► 1. Lock nut 2. Flex wheel 3. Back up pad 4. Inner flange
Follow instructions for depressed center wheel but also
use back up pad over wheel. See order of assembly on
accessories page in this manual.
Installing or removing abrasive disc
Optional accessory
1
2
3
► 1. Sanding lock nut 2. Abrasive disc 3. Rubber pad
1.
Mount the rubber pad onto the spindle.
2.
Fit the disc on the rubber pad and screw the sand-
ing lock nut onto the spindle.
3.
Hold the spindle with the shaft lock, and securely tighten
the sanding lock nut clockwise with the lock nut wrench.
To remove the disc, follow the installation procedure in reverse.
NOTE: Use sander accessories specified in this man-
ual. These must be purchased separately.
Installing abrasive cut-off / diamond
wheel
Optional accessory
/ diamond wheel, be sure to use only the special
wheel guard designed for use with cut-off wheels.
1
grinding.
► 1. Lock nut 2. Abrasive cut-off wheel / diamond
As for the installation, follow the instructions for
depressed center wheel.
The direction for mounting the lock nut and the
inner flange varies by wheel type and thickness.
Refer to the following figures.
When installing the abrasive cut-off wheel:
► 1. Lock nut 2. Abrasive cut-off wheel (Thinner than 4
12 ENGLISH
WARNING:
When using an abrasive cut-off
WARNING:
NEVER use cut-off wheel for side
1
2
wheel 3. Inner flange 4. Wheel guard for abrasive
cut-off wheel / diamond wheel
1
2
4
mm (5/32")) 3. Abrasive cut-off wheel (4 mm (5/32")
or thicker) 4. Inner flange
3
4
1
3
4
Publicité
