Publicité
Les langues disponibles
Les langues disponibles
4
3
015212
To remove the blade, press the shaft lock so that the
blade cannot revolve and use the wrench to loosen the
hex bolt counterclockwise. Then remove the hex bolt,
outer flange and blade.
3
4
015216
When changing blade, make sure to also clean upper
and lower blade guards of accumulated sawdust. Such
efforts do not, however, replace the need to check lower
guard operation before each use.
1
2
3
011231
Mount the inner flange with its recessed side facing
outward onto the mounting shaft and then place saw
blade, outer flange and hex bolt.
BE SURE TO TIGHTEN THE HEX BOLT CLOCKWISE
SECURELY.
Hex wrench storage
015213
1. Hex wrench
2. Shaft lock
3. Loosen
4. Tighten
2
1
1. Inner flange
2. Saw blade
3. Outer flange
4. Hex bolt
1
2
1. Mounting shaft
5
2. Inner flange
3. Saw blade
4. Outer flange
5. Hex bolt
4
1. Hex wrench
1
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
Connecting a vacuum cleaner
(Optional accessory)
1
2
3
015214
2
015215
When you wish to perform clean cutting operation,
connect a Makita vacuum cleaner to your tool.
Replace the lever on the lower guard to the one
supplied with the dust nozzle. Install the dust nozzle on
the tool using the screw. Then connect a hose of the
vacuum cleaner to the dust nozzle as shown in the
figure.
OPERATION
CAUTION:
Be sure to move the tool forward in a straight line
•
gently. Forcing or twisting the tool will result in
overheating the motor and dangerous kickback,
possibly causing severe injury.
Always use a front grip and rear handle and firmly
•
hold the tool by both front grip and rear handle
during operations.
015217
Hold the tool firmly. The tool is provided with both a front
grip and rear handle. Use both to best grasp the tool. If
both hands are holding saw, they cannot be cut by the
8
1. Dust nozzle
2. Screw
3. Lever
1. Vacuum cleaner
2. Hose
1
Publicité
