Agilent Technologies Turbo-V 81-AG Notice De Mode D'emploi page 263

Where:

The following messages may be displayed instead of the pressure:
1
Figure 37
Where
Turbo-V 81-AG Rack Controller User Manual / 87-900-986-01
mBar shows the pressure value measured
GAUGE ERROR: indicates that the GAUGE is not present or is
not working
PRESSURE UNDER: indicates that a pressure below the
minimum threshold set has been measured (5x10
PRESSURE OVER: indicates that a pressure exceeding the
maximum threshold set has been measured (1x10
Pressing the COUNTERS key, the following is obtained:
C Y
T I M
COUNTERS
increase
decrease
LOW SPEED
CYCLE XXXX Number of start/stop cycles
TIME XXXXXm
C L E X
E X X
LS
AG
VACUUM TECHNOLOGIES
menu
Turbo-V 81-AG
Time of last cycle (minutes)
(I)
Technical Information
Use
-9
mBar)
3
mBar)
X X X
X X X m
R1
R2
MEASURES
next
previous
START/STOP
263/306
17